Atomic A3 Manual – DMX Channels
Coarse pitch position (0 = fully backward, 255 = fully forward).
Fine pitch position. Used in conjunction with Pitch (Coarse) to form a 16-bit number, allowing 65536 possible positions. Pitch (Coarse) is the high-order byte.
Coarse roll position (0 = fully left, 255 = fully right).
Fine roll position. Used in conjunction with Roll (Coarse) to form a 16-bit number, allowing 65536 possible positions. Roll (Coarse) is the high-order byte.
Movement force (0 = lowest, 255 = highest).
Movement maximum speed (0 = lowest, 255 = highest). If unsure, set this to be permanently 255.
TT Gain (TTi Units only)
Sets the gain (volume) of the tactile transducers (0 = lowest, 255 = highest).
TT LFC (TTi Units only)
Sets the LFC (Low Frequency Cut-off) of the tactile transducers (0 = lowest (20hz), 255 = highest (100hz)).
Used to issue one-shot commands to the unit. Must be set to 0 at all other times. Commands are as follows:-
It is recommended the command channel is set to the desired value for a minimum of 0.5 seconds before being reverted back to zero, to ensure the command is transmitted correctly.